Compaq External RAID Controller & Subsystem Bedienungsanleitung PDF herunterladen (Seite 60)

Connecting Terminal

3-9

3.2.3 NPC Onboard

NPC is short for Notification Processing Center, a sub-module for

use with system event notification.

To activate the NPC module, do the following:

1. Create an NPC configuration file (in a simple text file format)

using a text editor program.

2. Save it in the name of “agent.ini”

3. FTP it to the controller IP address, and then reset the controller

for the configuration to take effect.

Listed below is the sample configuration. Specify your

configuration using simple defining parameters as shown below.

[SNMP_TRAP]

ENABLED=0 (1=on; 0=off)

SEVERITY=1

COMMUNITY=public

RECEIVER1=XXX.XXX.XXX.XXX,2 ("2" specifies the level of

events to be received by this receiver)

[EMAIL]

ENABLED=0

SEVERITY=1

SUBJECT=Event Message

SMTP_SERVER=XXX.XXX.XXX.XXX

[BROADCAST]

ENABLED=0

SEVERITY=1

RECEIVER=XXX.XXX.XXX.XXX, 1

NOTE:

NPC will be automatically activated if any of the notifier settings

(email, SNMP, or broadcast) is set to “enabled.”

The configuration file is comprised of three major sections: SNMP, Email

and Broadcast. Each notifying method can be separately enabled or

disabled.

1 2 ... 55 56 57 58 59 60 61 62 63 64 65 ... 346 347

Keine Kommentare

Compaq External RAID Controller & Subsystem Bedienungsanleitung Seite 60