Compaq TL891 - DLT Tape Library Betriebsanweisung PDF herunterladen (Seite 22)

Chapter 2. Operation

EK–TL891–UG. A01 2–-7

The fourth line is a map of the magazine with numbers from 0 to 9 representing

the cartridge slots. The numbers which are present on this line indicate that a

cartridge is present in the corresponding slot of the magazine. An underline

means that there is no cartridge present in that slot. In Figure 2-5, the cartridges

from slots 3 and 5 are not in the magazine, but are in drives 0 and 1.

2.3.4 Fault Screen

When a fault is detected, a screen similar to Figure 2-6 appears. At the same

time, either the Drive Fault or the Loader Fault LED is illuminated.

Figure 2-6 Fault Screen

The first line in Figure 2-6 shows a numerical fault symptom code (FSC). The

second line shows a brief description of the error, in place of the words ‘Error

Description.’ The third and fourth lines will contain a one- or two-line message

describing the initial error recovery procedure (ERP) in place of the words shown

in the figure.

A list of the fault symptom codes (FSC) and error recovery procedures (ERP)

appears in

Chapter 5 - Diagnostics and Troubleshooting

2.4 Selecting Control Panel Display Modes

As previously described, the POST Screens, the Initialization Screen and the

Default Screen appear without operator or host intervention. The Fault Screens

appear whenever a fault occurs. The screens which follow appear in response to

operator actions.

2.4.1 The Mini-Library Menu Structure

Figure 2-7 shows the structure of the MiniLibrary menus.

Fault Code: XXXX

Error Description

ERP line 1

ERP line 2

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 112 113

Keine Kommentare

Compaq TL891 - DLT Tape Library Betriebsanweisung Seite 22