Compaq 370 Anleitung zur Fehlerbehebung PDF herunterladen (Seite 8)

Known issues

8 Compaq ProLiant ML370 G2 Document Part Number: 86-0935761-C

Secure Computing Corporation.

Product names used within are trademarks of their respective owners.

Known issues

The following are known issues on the Compaq ProLiant ML370 G2:

• If you have a Seagate STD2401LW 4mm DAT drive, you may be able to increase the data transfer rate.

To change the drive to synchronous mode and achieve higher data transfer rates, add the following text to

/etc/boot.local:

-parm aic0 busted_v3sync=t5

• To start the second processor add the following text to /etc/mp.config:

extclk

Save the change and then reboot.

• For the Compaq ProLiant ML370 G2 systems that contain a dual port or quad port NIC, note the following:

If the network traffic slows or comes to a stop after enabling the second processor, verify the MPS table

Mode in the ML370 G2 BIOS is set to

Full Table Mapped.

• If Sidewinder reports "

Unable to find floppy kernel on install media" followed by

fd0: no disk in drive", verify the following:

— The IDE controller is enabled.

— The CD-ROM drive is set-up to be the master device, or

— If the jumper on the CD-ROM is set to CS, verify the middle IDE cable connector is attached to the CD-

ROM.

• Sidewinder does not support the Hot Swap feature on the two 64 bit PCI slots.

Important: Opening the Hot Swap PCI slot release lever while Sidewinder is running causes a NMI

error.

NMI: port B(61)=a0<parity_error. Shutdown and turn the power off on the Compaq ProLiant

ML370 G2 before adding/removing a PCI card.

• If the Hot Swap PCI slot release lever is opened with a NIC installed, time-outs will scroll on the screen.

The following hardware is not supported in the Compaq ProLiant ML370 G2:

• The Compaq Smart Array 5i Raid Controller has not been tested on the ML370 G2 at this time.

• The Compaq Smart Array 431, 532, 5302, and 5304 PCI RAID Controllers are not supported.

1 2 3 4 5 6 7 8

Keine Kommentare

Compaq 370 Anleitung zur Fehlerbehebung Seite 8