Compaq AlphaServer DS20 Wartungshandbuch PDF herunterladen (Seite 152)

B-8 AlphaServer DS20 Service Manual

quit

The quit command exits the user from command mode and reconnects the serial

terminal to the system console port. The following message is displayed:

Focus returned to COM port

Upon entering a carriage return, the system returns to either the console or the

operating system depending upon which was running when the RCM was invoked.

reset

The reset command requests the RCM to reset the hardware. The reset command is

equivalent to pressing the Reset button on the control panel.

RCM>reset

Focus returned to COM port

The following events occur when the reset command is executed:

•

The system restarts and the system console firmware reinitializes.

•

The console exits RCM command mode and reconnects the serial terminal or

console monitor to the system COM1 serial port.

•

The system executes its normal power-up sequence.

setesc

The setesc command resets the default escape sequence for invoking RCM. The

escape sequence can be any character string. A typical sequence consists of 2 or

more characters, to a maximum of 15 characters.

NOTE: Be sure to record the new escape sequence. Although the factory defaults

can be restored if you forget the escape sequence, this requires resetting the EN

RCM switch on the RCM switchpack.

The following escape sequence consists of 5 iterations of the Ctrl key and the letter

“o”.

RCM>setesc

^o^o^o^o^o

RCM>

If the sequence entered exceeds 15 characters, the command fails with the message:

*** ERROR ***

When changing the default escape sequence, avoid using special characters that are

used by the system’s terminal emulator or applications.

Control characters are not echoed when entering the escape sequence. Use the status

command to verify the complete escape sequence.

1 2 ... 147 148 149 150 151 152 153 154 155 156 157 ... 181 182

Keine Kommentare

Compaq AlphaServer DS20 Wartungshandbuch Seite 152