Compaq Compaq Portable II Anleitung zur Fehlerbehebung PDF herunterladen (Seite 96)

Chapter 8.16 Mass Storage Device Assembly

To remove the mass storage device subassembly:

1. Complete the preparation procedure (see Section 8.2).

2. Remove the rear panel (see Section 8.4).

3. To remove the drive bezel, place your thumb on the rear side of the

drive bezel.

4. Pull the drive bezel away from the computer with your thumb.

(Figure 8-38).

5. Disconnect the following cables (shown in Figure 8-39) from the system

board:

o Diskette drive data cable

o Diskette drive power cable

o Fixed disk drive data cable

o Fixed disk drive power cable

1 2 ... 91 92 93 94 95 96 97 98 99 100 101 ... 165 166

Keine Kommentare

Compaq Compaq Portable II Anleitung zur Fehlerbehebung Seite 96