Compaq dx2818 - Microtower PC Spezifikationen PDF herunterladen (Seite 62)

Installing Additional Drives

When installing additional drives, follow these guidelines:

●

The primary Serial ATA (SATA) hard drive must be connected to the dark blue primary SATA

connector on the system board labeled SATA1.

●

Connect the first SATA optical drive to the white SATA connector on the system board labeled

SATA2.

●

Connect a second SATA optical drive to the orange SATA4 connector.

●

Connect a second SATA hard drive to the light blue SATA3 connector.

●

Connect a diskette drive to the connector labeled FLOPPY.

●

Connect a media card reader to the USB connector labeled F_USB2.

●

The system does not support Parallel ATA (PATA) optical drives or PATA hard drives.

●

You may install either a third-height or a half-height drive into a half-height bay.

●

If needed, HP has provided extra drive retainer screws on the interior of the front bezel that are

used to secure the drives in the drive cage. Hard drives use 6-32 standard screws. All other drives

use M3 metric screws. The HP-supplied 6-32 standard screws (1) are silver. The HP-supplied M3

metric guide screws (2) are black.

Figure 7-17 Extra Drive Retainer Screws Location

52 Chapter 7 Removal and Replacement Procedures Microtower (MT) Chassis

1 2 ... 57 58 59 60 61 62 63 64 65 66 67 ... 161 162

Keine Kommentare

Compaq dx2818 - Microtower PC Spezifikationen Seite 62