Compaq ProLiant Spezifikationen PDF herunterladen (Seite 22)

Removal and Replacement Procedures 2-9

Drive Tray

To remove a drive tray from a removable media bay:

WARNING: To reduce the risk of personal injury and to prevent damage to the equipment,

before removing the access panel, make sure that the server is powered down, all cables are

disconnected from the back of the server, and the power cord is disconnected from the

grounded (earthed) AC outlet.

NOTE: The drive trays in the removable media bays can be used to mount internal 3.5-inch hard drives.

1. Complete the preparation procedures. See “Preparation Procedures” earlier in this chapter.

2. Remove the front bezel. See “Front Bezel” earlier in this chapter.

3. Remove the access panel. See “Access Panel” earlier in this chapter.

4. Remove the screws on either side of the drive tray

, and then gently slide the drive tray

out of the front of the chassis

Figure 2-5. Removing a drive tray

To replace a drive tray, reverse steps 2 through 4.

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 77 78

Keine Kommentare

Compaq ProLiant Spezifikationen Seite 22