Compaq LTE Elite Betriebsanweisung PDF herunterladen (Seite 382)

100

101

1. Install the SCSI-2 drive (Section 9.15).

2. Connect the SCSI-2 signal and power cables (Figure F-2) as follows:

- Connect one end of the SCSI-2 signal cable [1] to the connector on the

system board.

- Connect the other end [2] to the connector on the rear of the drive.

- Connect the outside connector of the drive power cable [3] to the

connector on the rear of the drive.

- Be sure that the other end of the drive power cable [4] is connected

to the vertical circuit board.

NOTE: Cables and connectors are keyed to allow only a correct match.

Connectors on the drive may be in a different location than those

shown.

3. Replace the bottom cover on the expansion base.

4. If a Class 1 Laser label accompanied the SCSI-2 drive, attach the label

near the nameplate label on the bottom cover of the expansion base for

regulatory compliance. Do not block any ventilation openings.

1 2 ... 377 378 379 380 381 382 383 384 385 386 387

Kommentare zu diesen Handbüchern

Keine Kommentare

Compaq LTE Elite Betriebsanweisung Seite 382

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für PC / Workstation Barebones Compaq LTE Elite