Compaq StorageWorks NAS B3000 Spezifikationen

StorageWorks by CompaqNAS B3000Rack Installation InstructionsOpen Card Completely BeforeBeginning Installation ProceduresNOTICE© 2002 Compaq Informati

122Connect the Remote Insight Lights-Out Edition board power cordand the adapter to the power port.3412561127Connect the monitor to the video port on

8The NAS B3000 connection process is complete.Connecting the Power SourceConnect each power supply to a separate power source. Ifmultiple uninterrupti

Declaration of Conformity -United States onlyThis device complies with Part 15 of the FCC Rules andRegulations. Operation is subject to the following

Always make sure that the rack-mounting rails are completely level.WARNING: This product is very heavy. To reduce the risk of personalinjury or damag

Installing the Storage Enclosureinto the Rack513241Identify the storage enclosure rack-mounting hardware.Item DescriptionLeft rack-mounting bracketRig

When installing in a square-hole rack, position the left rack-mounting bracket 1 just behind the front vertical rail, aligning themiddle two rack-moun

Remove the I/O module/Environmental Monitoring Unit(EMU).Replace the hard drives.CAUTION: You must insert a hard drive or a drive "blank" i

Installing the Device into the RackIdentify the device rack-mounting hardware.Item DescriptionOne pair 26-inch slide rail assembliesRack-mounting brac

b. Secure the outer bracket rail to the rack-mounting bracketwith an 8-32 x 1/4-inch slotted screw.IMPORTANT Do not tighten screws until all three sc

Attach the handle to the sides of the NAS B3000.1112Fully extend the slide rails of the mounting bracket and set thehandles squarely on the rails.Atta

17The device rack installation is complete.Connecting the Device and theStorage EnclosureDevice Rear Panel ConnectorsItem ComponentAuxiliary serial kn