Compaq DS10 Bedienungsanleitung PDF herunterladen (Seite 59)

Installing the TurboLinux V6.0 Distribution 4-13

4.6.2 Partitioning Procedure

NOTE: Type "p" after each main step in the procedure to verify the information

you have specified.

CAUTION: If there is partition information already configured for the disk,

delete it with the "d" option. Be sure you want to zero out this drive.

All data on the drive will be lost.

1. Choose option "b" to make a BSD disklabel. Answer Y to the following

message:

/dev/sda contains no disklabel. Do you want to create a disklabel? (y/n) Y

Delete the "c" partition.

Create the "a" (swap) partition and type the starting and ending cylinder

numbers. Always start at cylinder 2 for the first partition (swap). Do the

same to create the "b" (/root) partition.

Type "p" to print the partition table. The fstype is set to unused for each of

the partitions. You will set each partition’s filesystem ID. For each

partition, type "t" to change the partitions’ filesystem ID, enter the letter for

the partition, then enter the system ID for the partition, as indicated below:

Partition Filesystem ID

a (swap)

b (/ root)

Type "p" to print the partition table and verify all your settings.

Type "w" to write the disklabel to the disk.

Type "q" to quit.

NOTE: For more information on creating partitions, see the Installation Guide

provided by the software distribution vendor.

1 2 ... 54 55 56 57 58 59 60 61 62

Keine Kommentare

Compaq DS10 Bedienungsanleitung Seite 59