Compaq Compaq Portable II Spezifikationen PDF herunterladen (Seite 79)

NOTE: Controller and expansion board retaining screws may be located either

inside or outside the chassis.

To replace the fixed disk drive controller board, reverse Steps 1 through 3.

>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>><<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<

CAUTION

Ensure that the retainers on the bottom side of the board slots access plate

fit securely onto each board installed in your computer. If you changed to a

board of a different height, rotate the retainers to match the height of the

board. If the retainers are not rotated, serious internal damage may result!

>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>><<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<

Video Display Controller Board Removal and Replacement

To remove the video display controller board:

1. Complete the Board Slots Access Plate Removal procedure (see Section 7.4).

2. Disconnect the fixed disk drive controller board signal cables, if

installed (Figure 7.9-2).

1 2 ... 74 75 76 77 78 79 80 81 82 83 84 ... 128 129

Keine Kommentare

Compaq Compaq Portable II Spezifikationen Seite 79