Compaq Armada 1120T Anleitung zur Fehlerbehebung PDF herunterladen (Seite 146)

4. Place the display shield tabs in the indentations on the sides of the

CSTN (10.4 in) panel (Figure 5-94).

5. Align the CSTN (10.4 in) panel, display cable, and shield in the

display enclosure and replace the screws. Before replacing the screw in

the lower-left corner, route the XOVER board ground wire around the

boss at the bottom of the display enclosure. Hold the end of the wire

over the screw hole and install the screw, attaching the wire. Ensure

that the ZIF connector end of the display cable and the end of the

display ground cable are exposed at the bottom of the display enclosure

(Figure 5-95).

1 2 ... 141 142 143 144 145 146 147 148 149 150 151 ... 197 198

Keine Kommentare

Compaq Armada 1120T Anleitung zur Fehlerbehebung Seite 146