Compaq W4000 Bedienungsanleitung Seite 93
- Seite / 229
- Inhaltsverzeichnis
- LESEZEICHEN
Bewertet. / 5. Basierend auf Kundenbewertungen
Chapter 5 Input/Output Interfaces
Table 5–5. Diskette Drive Interface Control Registers
Table 5-5.
Diskette Drive Interface Control Registers
Pri.
Addr.
Sec.
Addr.
Register
R/W
3F0h 370h Status Register A:
<7> Interrupt pending
<6> Reserved (always 1)
<5> STEP pin status (active high)
<4> TRK 0 status (active high)
<3> HDSEL status (0 = side 0, 1 = side 1)
<2> INDEX status (active high)
<1> WR PRTK status (0 = disk is write protected)
<0> Direction (0 = outward, 1 = inward)
R
3F1h 371h Status Register B:
<7,6> Reserved (always 1’s)
<5> DOR bit 0 status
<4> Write data toggle
<3> Read data toggle
<2> WGATE status (active high)
<1,0> MTR 2, 1 ON- status (active high)
R
3F2h 372h Digital Output Register (DOR):
<7,6> Reserved
<5,4> Motor 1, 0 enable (active high)
<3> DMA enable (active high)
<2> Reset (active low)
<1,0> Drive select (00 = Drive 1, 01 = Drive 2, 10 = Reserved, 11 = Tape drive)
R/W
3F3h 373h Tape Drive Register (available for compatibility) R/W
3F4h 374h Main Status Register (MSR):
<7> Request for master (host can transfer data) (active high)
<6> Transfer direction (0 – write, 1 = read)
<5> non-DMA execution (active high)
<4> Command busy (active high)
<3,2> Reserved
<1,0> Drive 1, 2 busy (active high)
Data Rate Select Register (DRSR):
<7> Software reset (active high)
<6> Low power mode enable (active high)
<5> Reserved (0)
<4..2> Precompensation select (default = 000)
<1,0> Data rate select (00 = 500 Kb/s, 01 = 300 Kb/s, 10 = 250 Kb/s, 11 = 2/1
Mb/s)
R
W
3F5h 375h Data Register:
<7..0> Data
R/W
3F6h 376h Reserved --
3F7h 377h Digital Input Register (DIR):
<7> DSK CHG status (records opposite value of pin)
<6..0> Reserved (0’s)
Configuration Control Register (CCR):
<7..2> Reserved
<1,0> Data rate select (00 = 500 Kb/s, 01 = 300 Kb/s, 10 = 250 Kb/s, 11 = 2/1
Mb/s)
R
W
NOTE: The most recently written data rate value to either DRSR or CCR will be in effect.
5-6 Compaq Evo and Workstation Personal Computers
Featuring the Intel Pentium 4 Processor
Second Edition – January 2003
- Technical Reference Guide 1
- 3
- TABLE OF CONTENTS 7
- LIST OF FIGURES 13
- LIST OF TABLES 15
- Chapter 1 19
- INTRODUCTION 19
- 1.4 SERIAL NUMBER 20
- 1.5 NOTATIONAL CONVENTIONS 21
- 1.5.1 VALUES 21
- 1.5.2 RANGES 21
- Chapter 2 27
- SYSTEM OVERVIEW 27
- 2.2 FEATURES AND OPTIONS 28
- 2.2.1 STANDARD FEATURES 28
- 2.2.2 OPTIONS 29
- 2.3 MECHANICAL DESIGN 30
- 2.3.1 CABINET LAYOUTS 31
- 2.3.1.1 Front Views 31
- 2.3.1.2 Rear Views 32
- 2.3.2 CHASSIS LAYOUTS 33
- 2.3.3 BOARD LAYOUTS 36
- 2.4 SYSTEM ARCHITECTURE 38
- 2.4.2 CHIPSET 41
- 2.4.3 SUPPORT COMPONENTS 41
- 2.4.9 GRAPHICS SUBSYSTEM 43
- 2.4.10 AUDIO SUBSYSTEM 44
- 2.5 SPECIFICATIONS 44
- Chapter 3 47
- PROCESSOR/ 47
- MEMORY SUBSYSTEM 47
- 3.2 PENTIUM 4 PROCESSOR 48
- 3.2.1 PROCESSOR OVERVIEW 48
- 3.2.2 PROCESSOR UPGRADING 50
- 3.3 MEMORY SUBSYSTEM 51
- Chapter 4 55
- SYSTEM SUPPORT 55
- 4.2 PCI BUS OVERVIEW 56
- 4.2.2 PCI BUS MASTER ARBIT 61
- Second Edition – January 2003 62
- 4.2.7 PCI CONFIGURATION 63
- 4.2.8 PCI CONNECTOR 64
- 4.3 AGP BUS OVERVIEW 65
- BUS TRANSACTIONS 65
- Data Request 66
- 4.3.1.2 Data Transfers 66
- AGP 2X Transfers 67
- A 4X Tra 67
- GP nsfers 67
- 4.3.2 AGP CONFIGURATION 68
- .3.3 AGP CONNECTOR 69
- 8259 Mode 71
- APIC Mode 71
- MI- Generation 72
- Non-Maskable Interrupts 72
- SMI- Generation 73
- 4.4.2 IRECT MEMORY ACCESS 74
- DMA Page Registers 75
- 4.4.2.2 trolle gi 76
- DMA Con r Re sters 76
- CLE NG CMOS 78
- STANDARD CMOS LOCATIONS 79
- .7.1.5 Chassis Security 81
- 4.7.2 POWER MANAGEMENT 82
- SYSTEM STATUS 82
- RM EN AND COOLING 83
- 4.7.4 HE 83
- T AL S SING 83
- SYSTEM I/O MAP 85
- Chapter 5 88
- INPUT/OUTPUT INTERFACES 88
- 5.2.2 IDE CONNECTOR 90
- 5.4 SERIAL INTERFACE 95
- 5.4.1 SERIAL CONNECTOR 95
- 5.5 PARALLEL INTERFACE 98
- 5.6.3.1 8042 Configuration 105
- 5.6.3.2 8042 Control 106
- 5.7.1 USB DATA FORMATS 109
- 5.7.2 USB PROGRAMMING 111
- 5.7.2.1 USB Configuration 111
- 5.7.2.2 USB Control 111
- 5.7.3 USB CONNECTOR 112
- 5.7.4 USB CABLE DATA 112
- 5.8 AUDIO SUBSYSTEM 113
- 5.8.1 FUNCTIONAL ANALYSIS 113
- 5.8.2 AC97 AUDIO CONTROLLER 115
- 5.8.3 AC97 LINK BUS 115
- 5.8.4 AUDIO CODEC 116
- 5.8.5 AUDIO PROGRAMMING 117
- 5.8.5.1 Audio Configuration 117
- 5.8.5.2 Audio Control 117
- 5.8.6 AUDIO SPECIFICATIONS 118
- 5.9.1 WAKE ON LAN SUPPORT 120
- 5.9.2 ALERT ON LAN SUPPORT 120
- 5.9.3.1 APM Environment 121
- 5.9.3.2 ACPI Environment 121
- 5.9.4 NIC PROGRAMMING 122
- 5.9.4.1 Configuration 122
- 5.9.4.2 Control 122
- 5.9.5 NIC CONNECTOR 123
- 5.9.6 NIC SPECIFICATIONS 123
- 5.9.7 NIC UPGRADING/CHANGING 124
- Chapter 6 126
- POWER and SIGNAL 126
- DISTRIBUTION 126
- 6.2.1 POWER SUPPLY ASSEMBLY 127
- 6.2.2 POWER CONTROL 128
- 6.2.2.1 Power Button 128
- 6.2.2.3 Wake Up Events 129
- 6.2.3 POWER MANAGEMENT 130
- 6.3 POWER DISTRIBUTION 131
- 6.4 SIGNAL DISTRIBUTION 134
- Second Edition- January 2003 137
- Chapter 7 138
- BIOS ROM 138
- 7.2 ROM FLASHING 139
- 7.2.1 UPGRADING 139
- Second Edition - January 2003 140
- 7.3 BOOT FUNCTIONS 141
- 7.3.1 BOOT DEVICE ORDER 141
- 7.3.4 BOOT ERROR CODES 142
- 7.4 SETUP UTILITY 143
- 7.5.2 EDID RETRIEVE 151
- 7.5.3 TEMPERATURE STATUS 152
- 7.5.4 DRIVE FAULT PREDICTION 152
- 7.6 PNP SUPPORT 152
- 7.6.1 SMBIOS 153
- 7.7.2 ACPI SUPPORT 156
- 7.7.3 APM 1.2 SUPPORT 156
- System Timer 158
- IDE Hard Drive Timer 158
- System/Hard Drive Standby 159
- System Suspend 159
- System OFF 160
- 7.7.3.3 Waking Up in APM 160
- 7.8 USB LEGACY SUPPORT 160
- Appendix A 162
- ERROR MESSAGES AND CODES 162
- Changed - November 2000 173
- Appendix B 174
- ASCII CHARACTER SET 174
- Appendix C 176
- KEYBOARD 176
- C.2 KEYSTROKE PROCESSING 177
- Changed - July 2000 179
- C.2.3 KEYBOARD LAYOUTS 180
- C.2.4 KEYS 183
- C.2.4.3 Windows Keystrokes 184
- C.2.5 KEYBOARD COMMANDS 186
- C.2.6 SCAN CODES 186
- Continued 189
- C.3 CONNECTORS 191
- Appendix D 192
- COMPAQ/NVIDIA VANTA LT 192
- AGP GRAPHICS CARD 192
- D.2 FUNCTIONAL DESCRIPTION 193
- D.3 DISPLAY MODES 194
- D.6 CONNECTORS 196
- D.6.1 MONITOR CONNECTOR 196
- Changed - October 2000 197
- Appendix E 198
- COMPAQ/NVIDIA QUADRO2 EX/MXR 198
- AGP GRAPHICS CARDS 198
- E.2 FUNCTIONAL DESCRIPTION 199
- E.3 DISPLAY MODES 200
- E.6 CONNECTORS 202
- E.6.1 MONITOR CONNECTOR 202
- Changed - October2001 203
- Appendix F 204
- F.2 FUNCTIONAL DESCRIPTION 205
- F.3 DISPLAY MODES 206
- F.6 CONNECTORS 208
- F.6.1 MONITOR CONNECTOR 208
- Appendix G 210
- G.2 FUNCTIONAL DESCRIPTION 211
- G.3.2 SCSI ADAPTER CONTROL 212
- G.4 SPECIFICATIONS 212
- G.5 SCSI CONNECTORS 213
- Appendix H 216
- PCI GRAPHICS CARD 216
- H.2 FUNCTIONAL DESCRIPTION 217
- H.3 DISPLAY MODES 219
- Original - March 2002 220
- H.7 CONNECTORS 222
Verwandte Produkte und Handbücher für Computers Compaq W4000
Computers Compaq AERO 2100 Bedienungsanleitung
(192 Seiten)
(192 Seiten)
Computers Compaq EXS Series Bedienungsanleitung
(78 Seiten)
(78 Seiten)
Computers Compaq GS60E Bedienungsanleitung
(16 Seiten)
(16 Seiten)
Computers Compaq PRESARIO S0000 Bedienungsanleitung
(123 Seiten)
(123 Seiten)
Computers Compaq PROLIANT ML370 Bedienungsanleitung
(152 Seiten)
(152 Seiten)
Computers Compaq DL580 Bedienungsanleitung
(28 Seiten)
(28 Seiten)
Computers Compaq DA-10832 Bedienungsanleitung
(20 Seiten)
(20 Seiten)
Computers Compaq 4000N Bedienungsanleitung
(196 Seiten)
(196 Seiten)
Computers Compaq ALPHA GS320 Bedienungsanleitung
(29 Seiten)
(29 Seiten)
V7 PA19HBLK-2N Handbücher
Bedienungsanleitungen und Benutzerhandbücher für Handyhüllen V7 PA19HBLK-2N.
Wir stellen 1 PDF-Handbücher V7 PA19HBLK-2N zum kostenlosen herunterladen nach Dokumenttypen zur Verfügung Datenblatt
Kommentare zu diesen Handbüchern